3. Use an adequate press to remove the bearing from the shaft.
Control Removal
1. Remove control screws (D250) using a 5 mm internal hex wrench. Remove the control from the pump
2. Remove and discard the gasket (D150).
3. Using a 13 mm deep well socket wrench, remove feedback pin (D200) from top of swashplate.
4. If necessary, remove the screen (D084).
C
Caution
Screen (D084) may be loose and fall out of control. Take caution not to lose it.
5. If necessary, remove orifices (F100) using a 3 mm internal hex wrench.
Dowel pins (D300) are a press fit and will remain in housing.
Remove control
E101 404E
D250 (6X)
5 mm
D150
D200
13 mm
D300 (2X)
D084
F100
3 mm
Repair Instructions
H1 45/53/60/68 Closed Circuit Axial Piston Pumps
Disassembly
520L0957 • Rev CB • September 2014
9