48
Manual RS8EF402 © Danfoss 02-2009
AK-SM 350 Version 1.7x
Settings
To construct a template, start with the AK-SM 350 “Point detail” display screen.
The display screen is divided into 5 sections. The first 4 are shown below::
Left-hand side: 4 symbols, e.g. fan, refrigeration, defrosting, alarm
Top middle: The most important display, e.g. the appliance temperature (This display is also shown in the point over
view.)
Bottom middle: A secondary display, e.g. the temperature at the defrosting sensor
Right-hand side: Secondary display, e.g. alarm limits and time delays
The fifth section is a little further to the right and may contain more details.
The following pages show the settings for the individual sections
General
1. Select the section you want to set up (the section is shown with
a red border)
2. Then go to the “Properties” field and
select a parameter
Select the top line and find the parameter you want to display in
the field. You can read about parameter groups in the controller
manual, and also find more information about the function.
Double-click on the group to display a range of parameters. Se-
lect the parameter (in our example “u59 Fan relay”) and confirm
with “OK”.
3. The next page contains the specific settings for the individual
sections.
You can set up several “Views” for the same control-
ler type. You can decide which view you want to
use when setting up the point.