29
7.3
Operation
Put the locomotive on the programming track and readout the programming parameters of the decoder. The default
falue should be 01-532. Program the desired locomotive address and start running the locomotive with those
parameter values. After the first check you can vary the parameters of the engine freels to your requirements.
In case your programming device indicates "Error", please check again the correct wiring of the locomotive and pay
attention to the wiring instructions for connecting the programming track. Never put such a locomotive into operation!
7.4
Explanation of the brake section
1-part brake section:
In front of the signal section one track is controlled by a diode. The decoder must be programmed on 1-part brake
section (-). The locomotive decelerates to stop.
2-part brake section:
In front of the signal there are two track sections. The first one is controlled by a diode. The locomotive
decelerates to internal speed step 3 in this section. The second one is without supply, thus the locomotive stops
just in front of the signal. In this case the decoder must be programmed on 2-part brake section (=).
Summary of Contents for DH05C
Page 68: ...68 Blank page for your notes...
