45
9.2
Programming with Märklin-central unit 6020/6021
1
'Short'
programming allows entering figures between 0 and 79, i.e. in short mode just setup parameters with val-
ues from < 80 can be changed, if the desired value should also be < 80.
2
'Long'
programming allows entering figures between 0 and 255 einzugeben, i.e. in long mode all setup parame-
ters with values from 0 to 255 can be changed. As the display of 6020/6021 alows only binary values, the inserting
values must be devided and entered in two steps.
3
Programming of SUSI parameters.
Please notice that 6021/6020 allows only entering values from 01 to 80. Value 0 is missing.
Instead of '0' always '80'
must be entered.
Changing to programming mode
The driving controller must display 0. There may not be other locomotives on the layout.
Notice the flashing signal of the locomotive!
Push STOP- and GO-button of 6021 simultanously until reset will be triggered (alternatively: disconnect for a mo-
ment the plug of the transformer). Push STOP-button for disconnecting the track power.
Enter the current decoder address. If you dont know the address, enter '80'.
Revert the driving direction with the driving controller (turn the driving controller to the left beyond the keystroke
until your hear a click), hold the controller and and push GO-button.
After about one seconde the lights of the engine are falshing, the decoder is now in programming mode.
Summary of Contents for DH05C
Page 68: ...68 Blank page for your notes...
