12
19 piс.
20. Put 1850x400 mm side-end part (4th sheet in polycarbonate cutting diagram) and side-
end polycarbonate part, that you have cut-out, side by side and connect them with plastic H
connection profile (33). Screw connected polycarbonate sheet to corners of polycarbonate
installation and pole installation corners (20; 21) and polycarbonate installation plates (22)
by using screws M5-40 (28), nuts (29) and spacers (31). Attach to posts of back end part of
greenhouse by using screws M5-40 (28), nuts (29) and spacers (31) and then cut polycarbonate
according to framework profile by using sharp knife or jigsaw (20 pic).
Use appropriate side of polycarbonate! Side with protective layer, which protects from
UV radiation, must be on the outside. Protective layer is covered with plate which
contains writings; other side (which has to be on the inside) is covered with clear tape.
If sheets need to be cut, we recommend using electric saw, handsaw with fine teeth or
sharp knife. Tape must be removed prior to installation! ALWAYS WEAR GLOVES
WHEN CUTTING!
20 piс.
Cutting line
1
(33)
Rear greenhouse part
