1
8
5.Assembling the covers
Before assembling the cover, all the ground anchors must be placed
deep and all braces must be installed and clamped loosely.
Important:
Do not pull the covers with raw force, because noticeable
resistance could also indicate inaccurate alignment in the assembly. If
required, pull back again and try or check the accuracy of the assembly.
5.1 Roof covers
5.1.1
Throw one pulling ropes each from left to right over the ridge of the
first brace field (image 9 above, page 18), assembly fork will be useful
here.
5.1.2
Pull both the other pulling ropes over the ridge by using this rope.
5.1.3
Mount roof covers (image 10, page 20), ensure correct position and
readjust if needed.
5.1.4
Suspend both the pulling ropes into the two outer eyelets of the roof
cover using snap hooks opening facing upwards. Pull back the 3rd Mount
pulling rope into the drawbar eyelet as pulling rope (image 10).
5.1.5
Lift the roof cover to piping channel height by pulling the pulling
ropes from the opposite side of the marquee and insert the left and right
piping of the covers into the piping channel of the bar.
(Image 10, page 20)
5.1.6
Place the roof cover into the roof bar at both the pulling ropes with
uniform pulling.
Important
Pull the cover over the ridge in single pull.
5.1.7
Once the cover is pulled over bar completely, the two pulling ropes
will loosened and mounted in the 3rd rope, which was pulled with the
cover over the ridge. Pull back the 3rd rope so that both the other pulling
ropes are in initial position.
5.1.8
Repeat points 5.1.1 to 5.1.7 for other roof covers.
