Safety 05/2008
Danaher
Motion
6
S200-CNS Product Manual
2 SAFETY
2.1 S
AFETY
S
YMBOLS
WARNING
Warnings alert users to potential physical danger or harm. Failure
to follow warning notices could result in personal injury or death.
CAUTION
Cautions
direct attention to general precautions which, if not
followed, could result in personal injury and/or equipment damage.
NOTE
Notes highlight information critical to your understanding or use of
the product.
2.2 S
AFETY
N
OTES
•
As the user or person applying this unit, you are responsible for determining the suitability of this
product for the application. In no event will Danaher Motion be responsible or liable for indirect or
consequential damage resulting from the misuse of this product.
WARNING
READ these instructions before connecting power. Damage can result
from MISWIRING at the power terminals.
DANGEROUS voltages are present on power input and motor output
terminals.
•
Only qualified personnel are permitted to transport, assemble, commission, and maintain this
equipment. Properly qualified personnel are persons who are familiar with the transport, assembly,
installation, commissioning and operation of motors, and who have the appropriate qualifications
for their jobs.
•
Read all available documentation before assembling and using. Incorrect handling of products
described in this manual can result in injury and damage to people and/or machinery. Strictly
adhere to the technical information regarding installation requirements.
•
Keep all covers and cabinet doors shut during operation.
•
Be aware that during operation, the product has electrically charged components and hot surfaces.
•
Control and power cables can carry a high voltage, even when the motor is not rotating.
•
Never disconnect or connect the product while the power source is energized.
•
After removing the power source from the equipment, wait at least 5 minutes before touching or
disconnecting sections of the equipment that normally carry electrical charges (e.g., capacitors,
contacts, screw connections). To be safe, measure the electrical contact points to each other and
to electrical safety earth with a meter before touching the equipment.