DANA Spicer Torque-Hub W3B Series, Service Manual

Page: 29 / 54

29
9. Place Hub (1G) onto Spindle (1A) making sure the Seal (1B) is in position on the seal
shoulder of Spindle (1A).
NOTE: The Bearing Cone (1F) is a press fit onto Spindle (1A) and is installed using Snap
Ring Assembly Tool T205660
10. Place Snap Ring Assembly Tool T205660 onto Spindle (1A).
11. Place Bearing Cone (1F) onto the tapered portion of Snap Ring Assembly Tool T205660.
12. Place Spacer (1H) and Retaining Ring (1I) onto the top of the Bearing Cone (1F).
13. Slowly press Bearing Cone (1F) Spacer (1H) and Retaining Ring (1I) all at once using a
Bearing Pressing Tool, T137970, until the Retaining Ring (1I) falls into the retaining ring
groove on the Spindle (1A.)
14. Install Pipe Plug (1J) into Hub (1G).
15. Grease and install O-Ring (5) into Hub (1G).
16. Grease and install Thrust Washer (7) into Spindle (1A).
17. Install Spring (8) into Spindle (1A) until it Bottoms on Thrust Washer (7).
18. Grease and place second Thrust Washer (7) on Spring (8).
19. Using retaining ring pliers, push Retaining Ring (9) against Thrust Washer (7) until retaining
ring snaps into place in the Spindle (1A) groove.
This concludes the Housing-Spindle Subassembly.