DANA Spicer Torque-Hub W3B Series, Service Manual

Page: 35 / 54

35
13. Install Cover Sub-Assembly onto the Ring Gear (4) being sure that the pipe plugs in the Hub
(1G) and Cover (6A) are in time with each other. Be sure the Thrust Washers (15 & 16)
remain on the Cover (6).
14. Install four Shoulder Bolts (18) into the four marked counter bore holes in the Hub (1G). Start
Shoulder Bolts (18) by hand for the length of at least two threads or two full turns before
running down and torque to 45-47 ft-lbs
15. Place the remaining eight Bolts (17) into the remaining holes and torque to 45-47 ft-Lbs.
16. Turn the assembly over and insert Input Coupling Subassembly into the Spindle (1A)
counter bore.
17. The unit should now be leak and roll checked as per instructions on page 5, and 6. The
motor can be reinstalled into the gearbox for the leak check to seal it off, and the unit
pressurized through a pipe plug hole on the cover.
This concludes the Main assembly.