Piranha HN RoHS User Manual
03-032-20135-00
Teledyne DALSA
56
Error Messages
Error 05: Command unavailable in this
mode>
E.g. SSF when in SEM 3
Error 06: Timeout>
Command not completed in time. E.g. CCF in SEM 3 when no
external EXSYNC is present.
Error 07: Camera settings not saved>
Indicates that user settings have been corrupted by turning off the
power while executing the WUS command. Must build up new
settings from factory and re-save with WUS.
Error 08: Unable to calibrate - tap outside
ROI>
Cannot calibrate a tap that is not part of the end of line statistics.
Error 09: The camera's temperature exceeds
the specified operating range>
Indicates that the camera has shut itself down to prevent damage
from further overheating. (flashing red)
Shuts down at internal temperature of 75˚C and will not restart until
below 65˚C (equivalent to 50˚C at front plate).
Error 10: FPGA Flash Program Failed
FCS failed either because of communication error or a bad file was
sent.
Commands: Quick Reference
As a quick reference, the following table lists all of the camera configuration commands available to the
camera user. For detailed information on using these commands, refer to
Chapter 3
. Note: This table does
not list “get” commands. Refer to
Returning Camera Settings
for a list of these commands.
Parameters:
t
= tap id
i
= integer value
f
= float
m
= member of a set
s
= string
x
= pixel column number
y
= pixel row number
Table 11: Command Quick Reference
Mnemonic
Syntax Parameters
Description
correction calibrate fpn
ccf
Performs FPN calibration and eliminates FPN noise by
subtracting away individual pixel dark current.
calculate camera gain
ccg
i
Calculates the camera
i
= Calibration target value in a range from:
4096
to
16064
DN (14 bit LSB).
camera link mode
clm
m
Sets the Camera Link configuration, number of Camera
Link taps, and data bit depth.
2
: Base configuration, 2 taps, 8 bit output
3
: Base configuration, 2 taps, 12 bit output
15
: Medium configuration, 4 taps, 8 bit output
16
: Medium configuration, 4 taps, 12 bit output
21
: Full configuration, 8 taps, 8 bit output
