Piranha HN RoHS User Manual
Teledyne DALSA
03-032-20135-00
47
Figure 20: How User Settings are Stored in the HN-xx Cameras after issuing the wus Command
You can save or restore your user settings to non-volatile memory using the following commands.
•
To save all current user settings to EEPROM for the current mode for both TDI shift directions, use
the command
wus
. The camera will automatically restore the saved user settings when powered up.
WARNING: While settings are being written to nonvolatile memory, do not power down
camera or camera memory may be corrupted.
•
To restore the last saved user settings for the current mode, use the command
rus
.
Current Session Settings
These are the current operating settings of your camera. These settings are stored in the camera’s volatile
memory and will not be restored once you power down your camera. To save these settings for reuse at
power up, use the command
wus
. Settings are saved for the current operating mode (TDI or Area) only.
Saves the Current User Settings
Purpose:
Saves the current user settings for the current direction and set number.
Syntax:
wus
Notes:
•
Available in TDI or area mode for sets 1 to 4.
Example:
wus
See also:
rus, rfs
Restores the Saved User Settings
Purpose:
Restores the saved user settings for the current direction and set number.
Syntax:
rus
Notes:
•
Available in TDI or area mode for sets 1 to 4.
Example:
rus
See also:
wus, rfs
Area Mode
User Settings
All settings
saved for Area
Mode only
Camera is operating
in TDI Mode
Camera is operating
in Area Mode
User issues
command
wus
START
TDI Mode
User Settings
All settings, except
pixel coefficients,
saved for TDI
Mode only.
