dallmeier DDF4510HDV-IM, Installation And Configuration Manual

Page: 23 / 105

DF4510HD | DF4910HD | DDF4510HDV-IM/-SM | DDF4910HDV-IM/-SM
www.dallmeier.com 23
To attach the lens, proceed as follows:

Remove the rear lens cap and the camera body cap.

Carefully screw the lens into the CS lens mount ( Fig. 5-1 ).

If using a DC auto iris lens, connect the lens cable to the DC auto iris interface ( Fig. 5-2 ).
By default, the camera is configured for the use with DC auto iris lenses.
If using a lens with manual iris control, you have to reconfigure the camera accordingly
(see section “ Sensor ” on page 56).
Video signal-controlled lenses are not supported.
6.1.2 Installation and Commissioning
The camera has a ¼" tripod socket located on the top and bottom side.
Notice
Damage to the device due to inappropriate mounting equipment

Use the correct type of mounting equipment:
• ¼" tripod screw (max. length 7 mm) for ceiling/wall bracket
•
Weather-proof housing for outdoor installations

Mount the camera to the ceiling/wall bracket using a suitable tripod screw.

Connect the required cables to the connectors on the back side of the camera (see
chapter “ Pin Assignment ” on page 96).

If necessary, connect a CVBS monitor to the video preview output.

If PoE (Power over Ethernet) is not available, first connect the camera to a suitable
power supply unit and then connect the power supply unit to the mains socket.

Align the camera with your scene and set the focal length and focus (loosen the corre-
sponding locking screws before making any adjustments and tighten them again when
finished).

Finally, disconnect the CVBS monitor from the video preview output.