20
Fig. 13
Note: 24V DC (1A), 120V AC (1A) voltage and current are suggested.
Section 5 PTZ (pan, tilt and zoom) control connection
Type
Ⅰ
4 channel model and type
Ⅱ
models’ (page.6) PTZ linkage should be as follows:
Fig. 14
A and B ends of RS485 can be connected with the Rx+, Rx- on PTZ or High Speed Dome.
Type
Ⅰ
16 channel model and type
Ⅲ
models’ (page.6) PTZ linkage should be as follows:
Fig. 15
T+ and T- ends of RS485 can be connected with the Rx+, Rx- on PTZ or High Speed Dome.
After all the above connection, please enter the “PTZ” menu to setup camera and PTZ address, baud rate, PTZ
protocol.
After the setup, click “
” icon on the status bar to enter the PTZ control interface. Also you can run the
DVR_WEB software or Netclient to control PTZ. About the DVR_WEB setting please refer “Chapter ”.
Ⅴ
Note: Type
Ⅰ
16 channel model (page.6) support 485
(
1
)
and 485
(
2
)
port, RS485
(
2
)
is set as default
,
If you want to use 485
(
1
)
port for PTZ control, please setup as following:
“Menu--Network--Serial Port Setup—PTZ Port
:
Port1”.
WARNING: PLEASE SET ALL OF THE PTZ ADDRESSES DIFFERENTLY.