Setup and Operation
17
Hearing Assist System Operation (Optional)
Basic instructions are described below and shown in
. For more information, refer
to the
Listen LT-800 Stationary Transmitter
,
Listen LR-4200 iDSP Receiver
, and
Listen LA-122
Universal Antenna Kit Users Manuals
.
1�
Press
POWER
to turn on the transmitter if it is not already on.
2�
Use the
CHANNEL SELECT
buttons to select a channel.
3�
Plug the Ear Phone/Neck Loop lanyard into the 2 jacks on top of the receiver, and
then connect the Ear Speaker into the jack on the lanyard.
4�
Press and hold the power button for 1 second to turn on the receiver. (To turn off the
receiver, press and hold the power button for 3 seconds.)
5�
Verify the channel number matches on both the receiver and the transmitter. To
change the channel, press and hold the up and down buttons at the same time for
5 seconds, and then use the up and down buttons to select the channel. Press the
power button to save.
Note:
Receivers use rechargeable Lithium-ion batteries. Always charge receivers at
least 2.5 hours before the event.
6�
Repeat steps
3–5
for any additional receivers.
1
2
3
4
5
Figure 26:
Optional Hearing Assist System
