Daktronics DVX-1830 Series, Installation Quick Manual

Page: 3 / 8

DVX-1830 Series Sectional
Installation Quick Guide
28 November 2016
DD3396953
Rev 00 201 Daktronics Drive Brookings SD 57006
800.325.8766
www.daktronics.com/support
Page 3 of 8
Side-to-Side Connection
1. Connect the sections side to side before making any top-to-bottom
connections.
2. Place the adjacent sections side by side so the alignment pyramids in each
nest inside the corresponding recesses.
3. Install
1
/
4
″ bolts (located in the blue interconnect hardware bag) horizontally
through all of the corner blocks in one cabinet and into the adjacent
cabinet’s corresponding corner block’s nutsert (four per side). Refer to
Figure 9 on page 3. Finger-tighten the bolts.
4. Use a
3
/
8
″ socket wrench to tighten the bolts. The minimum torque required
is 6 ft-lbs. Avoid over-tightening. After the corner blocks are tight together,
additional torque will not tighten the seams and can damage the blocks.
5. Inspect the corner blocks on the installed section visually to ensure the faces
shown in Figure 4 on page 2 and Figure 5 on page 2 are flush and
aligned.
6. Use a 4′ level to ensure the display faces are flush and flat to all adjacent
sections. Refer to Figure 6 on page 2.
Top-to-Bottom Connection
1. Connect the sections side to side before making any top-to-bottom
connections.
2. Place the adjacent sections on top of each other so the alignment pyramids
of each nest inside the corresponding recesses.
3. Install
1
/
4
″ bolts (located in the blue interconnect hardware bag) vertically
through all of the corner blocks in one cabinet and into the adjacent
cabinet’s corresponding corner block’s nutsert (four per side). Refer to
Figure 10 on page 3. Finger-tighten the bolts.
4. Use a
3
/
8
″ socket wrench to tighten the bolts. The minimum torque required is
6 ft-lbs. Avoid over-tightening. After the corner blocks are tight together, additional torque will not tighten
the seams and can damage the blocks.
5. Inspect the corner blocks on the installed section visually to ensure the faces shown in Figure 4 on page
2 and Figure 5 on page 2 are flush and aligned.
6. Use a 4′ level (when possible) to ensure the display faces are flush and flat to all adjacent sections. See
Figure 6 on page 2.
Figure 9: Installing Bolt through
Corner Block
Figure 10: Installing Bolt through
Corner Block