DVX-1830 Series Sectional
Installation Quick Guide
28 November 2016
DD3396953
Rev 00
201 Daktronics Drive Brookings SD 57006
800.325.8766
www.daktronics.com/support
Page 2 of 8
6.
Inspect the corner blocks on the installed sections visually to ensure the faces shown in
7.
Place a 4′ level at both ends and the middle of the display seam (when
possible) to ensure the display faces are flush, plumb, and flat to all adjacent
sections. Refer to Figure 6 on page 2. If they are no longer aligned, loosen the section interconnect
hardware and repeat Steps 4-7.
8.
Attach the clips to the structure by either welding or installing the self-drilling screws (located in the green
weldless hardware bag). Refer to
Figure 7 on page 2 and Figure 8 on page 2 for details and to the
Shop Drawing for requirements on welding and bolting.
Figure 4:
Inspecting Corner
Blocks (Side View)
Figure 5:
Inspecting Corner
Blocks (Top View)
Figure 6:
Ensuring Display Faces
Are Flush
Typical field
fillet weld
Figure 7:
Welded Attachment
Required
Optional for
adjustable
installation
(do not leave
unattended)
Figure 8:
Weldless Attachment
