47
NOTE: Remember that conveyor and spinner
speeds are also dependent upon the provided
hydraulic flow. Initial settings of the conveyor are
70 RPM for 410 and 412 models and 100 RPM for the
414 model. The 412 model may be set at 100 RPM.
When the Brake button is pressed, the Brake output will
ramp ON to the Brake Adjustment setting over a 2 second
period. When the Brake button is released the Brake output
will be turned OFF.
Pressing the appropriate button once allows each of the
functions to cycle ON. Pressing the button a second time will
cycle the function OFF.
Conveyor
Spinners
Throttle
Vibrate
The status of the conveyor and spinners is displayed by
icons on the buttons and in their RPM setpoint boxes. The
icon will be green in color when the function is ON and white
in color when the function is OFF.
The conveyor and spinners RPM setpoints are adjustable
while the function is either OFF or ON. The current setting
will then be saved.
NOTE: If equipped with the automatic rear door,
cycling of the conveyor will also open and close
the rear door.
NOTE: When two vibrators are present, one press
will activate one vibrator and a second pressing of
the button will switch activation (alternate) to the
opposite (non-active) vibrator.
Pressing either the Engine Start or Engine Stop button will
perform the function it is identified with.
Pressing the Preset button changes the right-hand side of
the view to the 4 presets set previously by the operator.
Selecting one of the presets will adjust the functions of Turf
Tender to the preset.
Pressing the NEXT button changes the controller screen to
the menu screen.
Menu Screen
In the Menu screen, the operator has access to the sand
and spinner reference information. The operator can also adjust
the GAIN of the brake and turn the side conveyor ON and
OFF. Access to the fault screen is made by pressing the fault
button.
Pressing the Side Conveyor button will cycle the side
conveyor between ON and OFF.
Pressing Brake Adjust button allows the ENCODER dial
to change the Gain of the Brake. The amount of GAIN will be
indicated in a percentage.
Fault Screen
In the menu screen, press the fault button to bring up the
fault screen.
When a fault has been indicated by the fault icon, press the
fault button to bring up the fault code table to identify which
function is experiencing a fault. Troubleshoot the wiring to the
function according to the fault code table. When the fault has
been corrected (usually a broken wire, loose connection, or
wire grounding on the frame), then press the Fault Reset button
to reset the fault.
NOTE: The Turf Tender will continue to operate even
with a fault indicated.
