44
CONVEYOR
Pressing the button will turn the
conveyor ON and OFF. When the conveyor is activated, the
ENCODER dial can adjust the conveyor speed. If equipped
with an electric rear door, the door will open prior to the
conveyor starting. When turning the conveyor OFF, the door
will close after the conveyor stops.
SPINNERS
Pressing the button will turn the
spinners ON and OFF. When the spinners are activated, the
ENCODER dial can adjust the spinners speed.
The status of the conveyor and spinners is displayed by
icons on the buttons and in their RPM setpoint boxes. The
icon will be green in color when the function is ON and white
in color when the function is OFF.
The conveyor and spinners RPM setpoints are adjustable
while the function is either OFF or ON. The current setting
will then be saved.
VIBRATE
Pressing the button will activate the vibrator.
When two vibrators are present, one press will activate one
vibrator and a second pressing of the button will switch
activation (alternate) to the opposite (non-active) vibrator.
PRESETS
When the PRESET button is pressed,
the 4 buttons on the right-hand side of the screen will change
to PRESET buttons 1-4. If one of the buttons is not pressed
for 15 seconds, the screen will change back to the home screen.
To set a preset, manually set the conveyor and spinner RPM;
then press (and hold for 2 seconds) any one of the PRESET
(P1-P4) buttons to save the setting. To use a preset, simply
press the desired PRESET button (for less than 2 seconds)
and the conveyor and spinner RPM will change to the saved
values.
If a preset is selected, the icon will show on the Home
Screen. If either the Conveyor or Spinner RPM is adjusted
while the Preset icon is showing, the icon will disappear.
Menu Screen
The Menu screen will show when the
NEXT
button is
pressed from the Home screen.
The Menu screen accesses the following displays:
1. Sand Reference
2. Spinner Setup Reference
3. Side conveyor ON and OFF.
4. Faults
5. Login
6. Brake Adjustment
S
IDE
C
ONVEYOR
Pressing the
SIDE CONVEYOR
button, will turn the side
conveyor ON and OFF. The normal setting of the conveyor is
OFF. When the Side Conveyor is ON, the Spinner function
will be in the manual mode.
B
RAKE
A
DJUST
When the
Brake Adjust
button is pressed, the
Encoder
knob is active and the GAIN of the brake may be adjusted.
Turning the dial clockwise increases the GAIN; turning the
dial counterclockwise decreases the GAIN. The GAIN
adjustment range is from 10% - 100%. The percentage of gain
is displayed on the screen.
S
AND
R
EF
Pressing the
Sand Ref
button will display the Sand
Reference chart. The Sand Reference chart shows
predetermined settings for spreading sand.
Spinner Setup Ref
Pressing the
SPINNER SETUP REF
button will display
the Spinner Setup screen. The Spinner Setup screen shows
how to set up the spinners for different spreading widths,
patterns, and problems.
Faults
If the proper input is not detected, the fault icon on the
Home Screen will be shown. If either a conveyor or spinner
fault is detected, the output will then be controlled based on a
percentage with no feedback.
Pressing the
Faults
button will display the Active Fault
screen. The Active Fault screen will display a table indicating
the message fault codes. The fault codes will be displayed as
numerical values. Refer to the Fault Code Table for the details.
It will also display a
Fault Reset
button. Pressing the
Fault
Reset
button will reset all active faults.
