12
9. Remove the remaining components from the skid.
NOTE: The electrical harness and miscellaneous
loose parts are stowed inside the pedestal.
Installing Harness And Control Box
TORO WORKMAN MODELS
1. Route electrical harness from the right rear hinge (1) along
hydraulic hoses above trans-axle to the left side near the
battery (2).
2. Continue along left side below the cab to the steering
shaft opening.
3. Route the harness up through the opening behind the brake
pedal.
4. Place the control box bracket in the desired mounting
location (within easy reach and view of the operator) on
the dash making sure there are no electrical wires in the
area (below the dash). Using the bracket as a template,
mark the location for the four mounting holes; then center
punch the holes.
5. Using a 1/4 in. drill bit, drill the holes in the dash. Using
the hardware included, secure the bracket to the dash;
tighten securely.
6. Place the control box onto the bracket and secure.
7. Attach the red wire eyelet to the positive terminal and the
black wire eyelet to the negative terminal of the battery
and pump/cooler harness; then connect the wiring harness
to the control box.
8. Using cable ties, secure the harness along its route to
prevent abrading, pinching, and contact with hot surfaces.
JOHN DEERE PROGATOR MODELS
1. Route the electrical harness from the right rear hinge (1);
to the battery area (2); over to the right frame rail (3);
then follow hydraulic tube lines beneath the passenger
seat (4).
SETUP
