14
2. Check engine oil and gasoline levels.
3. Check the position of the choke, fuel valve, throttle and
key switch. See the engine manual for proper use of each.
4. Ensure master switch on control box is in the OFF
position. Be sure all persons are clear of conveyor and
spinner areas; then using the key switch on the control
box, start the engine.
7. Jack up the rear of the hopper to take pressure off the
hinge pins; then remove them. Keep hinge pins with the
vehicle for the mounting of other units.
8. Drive straight ahead to clear hopper.
SELF-CONTAINED TURF TENDERS
Self-contained Turf Tenders have their own power supply
and hydraulic system. The power supply used is a Honda 11
hp engine. The engine provides power to the hydraulic pump
which draws hydraulic fluid from the reservoir and circulates
the fluid to the drive motors on the Turf Tender.
In addition to following the setup information for trailer-
type Turf Tenders, the following information must also adhered
to.
Before Operating For The First Time
1. Check the level of the hydraulic fluid. A sight gauge is
built into the front side of the reservoir. Fill as required.
2. Check the oil and gasoline levels in the engine. Fill as
required.
NOTE: The engine has oil fill/check caps and drain
plugs on both sides. The gray plug is the dipstick
and is located on the front side of the engine.
3. Read and understand all information in the Honda engine
Operator’s Manual.
Note: This engine has no Transmission/centrifugal
clutch; therefore, ignore pages 29-30 in the Honda
engine Operator’s Manual.
Before Starting Engine
1. Using the sight gauge, check the oil level in the hydraulic
reservoir.
SETUP
