96
GB
10 s max.
Press
*
then
#
on the
control panel keypad
Press & hold the
programming key 0
for 10 sec.
until the control panel responds
Carry out the programming sequence described below:
)
)
)
)
)
“beep, fire detector n° X”
You can record a personalised message to identify the fire detector by voice (see the
control panel installation manual, § on Voice identification message).
Connect the lithium battery making sure it is the right way round.
Ò
The red LED flashes for 15 sec, then once every 10 sec to indicate that the detector is
working normally.
2. Power supply
3. Recognition programming
iMPoRtAnt: during recognition programming, the product to be programmed for use with
the control panel does not need to be placed next to it. in fact, we recommend you place
the product at a short distance from the control panel (at least 2 m away).
Programming enables the heat detector to be recognised by the control panel.
To programme the heat detector, the control panel must be in installation mode. If it is not,
press:
then press:
master code
engineer installer code
then
Summary of Contents for 155-21X
Page 1: ...Upgraded for e Nova applications...
Page 20: ...2280612004 01 2013...
