DAITEM 155-21X, Installation Manual

Page: 10 / 20

102
GB
To test the heat detector, press on the test button (for roughly 10 sec.) until the built-in
sounding is triggered.
As long as the button is held down , the detector responds as follows:
As soon as the test button is pressed for more than 10 sec , and when connected to a
Daitem alarm system, the detector causes the following:
• triggering of the control panel and security system sirens in fire sounding mode for 5 minutes,
• triggering of the telephone dialler.
Stop the sirens and check that the control panel has memorised the alarm (see Indications
section).
iMPoRtAnt: these tests should be carried out at least
once a month and notably when you have been away for a
long time.
Heat detector
transmitting
the heat
detection signal
other hard-wired
interconnected
heat detectors
the LED flashes
quickly
the LED flashes
quickly
the alarm sounds
for 1 sec (75 dB(A)
at 3 m) and then
stops for 1 sec
a safety
halo lights up
every second
a safety
halo lights up
every second
Red LeD indicating
detector status
White LeD Sounding
the alarm sounds
for 1 sec (75 dB(A)
at 3 m) and then
stops for 2 sec