Contour Gen 2 Flex (Side Bend)
Installation Guide
7
Push into clips
Insert wire connectors
into weather box. Fill with
electrical grade silicone and
close box.
Secure the weather box using
a #6 or #8 (M2 or M3) screw.
Power
supply
Red (+)
Black or blue (–)
To Contour
Strip wires back 0.5 in. (13mm).
Connect the red wire (+)
from the LED strip to the red
wire (+) of the power supply.
Connect the black wire (-)
from the LED strip to the black
or blue wire (-) of the power
supply.Grounding and bonding
must be done in accordance
with National Electrical Code
(Article 600). See power supply
instructions.
Run a wire from the power
supply to a section of Contour.
Power supply connection
to the AC mains must be
completed in an acceptable
enclosure. Power supply
loading is described on
page 9.
Connect Power Supply
WARNING/AVERTISSEMENT
RISK OF ELECTRICAL SHOCK: Turn power OFF before inspection, installation or removal.
RISQUES DE CHOC ÉLECTRIQUE: Coupez l’alimentation électrique avant d’inspecter, d’installer ou de déplacer le luminaire.
8
11
9
10
To power supply
Red (+)
Black or
blue (–)
Weather box can be painted
Push each light
engine segment
into the clips.
4
Insert wire connectors
into weather box. Fill
with electrical grade
silicone and close
box. Weather box can
be mounted using #8
(M3) screws.
To connect two
light engines, first
strip wire ends back
0.5 in. (13mm). Then
join wires together
using twist-on wire
connectors.
Secure light engine
by twisting tie-wire
around the mounting
clip and light engine.
6
5
7
Weather
box can be
painted
+
–