Contour Gen 2 Flex (Side Bend)
Installation Guide
4
4.5 in. (114 mm)
Mount the Flex rails so that
they are gapped at least
4.5 in. (114 mm) apart if end
to end, using a #6 or #8
(M2 or M3) screw at least
every 2 ft. of rail but not less
than 2 screws per rail.
NOTE: For an 8 ft. rail
length, there will be 2.08 in.
(52.8 mm) of excess light
engine on each end.
Using the Flex Rail final length,
measure out the necessary
length of Contour LED light
engine so that it will extend
at least 3/4 in. (19 mm). If
required, use a sharp cutting
tool to cut through light engine
(refer to the
Cutting Resolution
Table
on page 2).
Installation
Plan the layout by measuring the design
layout and dividing by 8 ft . (2.44m)
to determine the required quantity of
Contour Gen 2 Flex. Refer to the Cutting
Resolution Table on page 3 when
cutting any Contour Gen 2 Flex section.
Do not use more than one suffix
code for each respective application,
as mixing suffix codes may result in
appearance variation. Suffix code can
be found on the packaging label.
NOTE: If mounting surfaces are rough or uneven, take the necessary precautions to avoid bending the rail when
mounting.
If you have any questions about these instructions or your specific Contour application, please contact support at
Planning First
METHOD A - Installing Light Engines With GEXNFRL-1 Flex Rail
- Straight Runs Only
1
2
For cut end, fill cap with
electrical grade silicone and
push cap on the end to seal.
Clean excess silicone.
3
Electrical grade
silicone
Cut on marks only
