Contour Gen 2 Flex (Side Bend)
Installation Guide
6
6-12 in.
(152-305 mm)
Plan the layout by measuring the design
layout and dividing by 8 ft . (2.44 m)
to determine the required quantity
of Contour Gen 2 Flex. Refer to the
Cutting Resolution Table on page 3
when cutting any Contour Gen 2 Flex
section.
Do not use more than one suffix
code for each respective application,
as mixing suffix codes may result in
appearance variation. Suffix code can
be found on the packaging label.
DO NOT bend the light engine to an inside radius that is tighter than 1 in. (25.4 mm).
If you have questions about these instructions or your Contour application,
contact support at [email protected]
Planning First
METHOD B - Installing Light Engines With GEXNFMC-1 Flex Mounting Clip
Install a Flex Mounting Clip,
using #6 (M2) counter sink
screws, every 6-12 inches
(152-305 mm) on center until
the end of the run is reached.
Installation
Using the light engine final
length, measure out the
necessary length of Contour
light engine so that it will
extend at least 3/4 in. (19 mm)
past the last mounting clip. If
required, use a sharp cutting
tool to cut through light engine.
For cut end, fill cap with
electrical grade silicone and
push end cap on the end to
seal. Clean excess silicone.
1
2
3
WARNING / AVERTISSEMENT
RISK OF FIRE: DO NOT bend the light engine to an inside radius that is tighter than 1 in. (25.4 mm).
RISQUE D’INCENDIE: Ne pas plier les modules DEL Contour avec un rayon de courbure inférieur à 1 pouce (25.4 mm).
Back bend
Side bend
Cut on marks only
Electrical grade
silicone
