Daikin SUT06S3016-30, Operating Manual

Page: 46 / 99

PIM00413
8-4
8.2
Filling hydraulic oil (Only SUT06, SUT10)
● Remove the cap of the oil filling port (air breather) by turning it counterclockwise, and fill clean hydraulic oil
(pollution degree: NAS Class 9 or lower level) into the tank. Set the oil level so that the float of the level gauge
is between the red and yellow lines.
●
Use the hydraulic oil conforming to the specifications. Refer to "3.2.2 Common Specifications "
● Make sure that the stop valve is opened.
Oil level
gauge
Stop valve
Please open it when using
(horizontal lever: Open, vertical lever: closed)
The stop valve is open
CAUTION
●
Operating the hydraulic unit with no oil in the tank or closing the stop valve causes pump seizure or wear,
which may result in pump damage.
● During initial operation of the machine, oil will be supplied into the hydraulic circuit of the machine. Be
careful about a decrease in oil level in the tank.
●
The oil level in the tank may largely fluctuate depending on the machine hydraulic circuit. This may result in
oil leak from the tank, or decrease in oil level. Please adjust the oil amount to be an optimal value while
watching the oil level meter.