![background image](http://html1.mh-extra.com/html/daikin/super-multi-plus-e-series/super-multi-plus-e-series_service-manual_3601835243.webp)
SiEN18-622
Instruction
System Configuration
231
ATTENTION
To use ON TIMER operation
•
Check that the clock is correct. If not, set the
clock to the present time.
1. Press “ON TIMER button”.
•
6:00
is displayed.
•
“
“blinks.
2. Press “TIMER Setting button” until the time
setting reaches the point you like.
•
Every pressing of either button increases or
decreases the time setting by 10 minutes.
Holding down either button changes the
setting rapidly.
3. Press “ON TIMER button” again.
•
The TIMER lamp lights up..
To cancel ON TIMER operation
4. Press “CANCEL button”.
•
The TIMER lamp goes off.
To combine ON TIMER and OFF TIMER
•
A sample setting for combining the two timers is
shown below.
In the following cases, set the timer again.
•
After a breaker has turned OFF.
•
After a power failure.
•
After replacing batteries in the remote control.
Di
s
pl
a
y
(Ex
a
mple)
Pre
s
ent time: 11:00 p.m.
(The
u
nit oper
a
ting)
OFF TIMER
a
t 0:00
a
.m.
ON TIMER
a
t 7:00
a
.m.
Com
b
ined
Summary of Contents for Super Multi Plus E-Series
