77
Indoor Unit Installation
1.
Installing the mounting plate
•
The
A
mounting plate is located at the back of the indoor unit. Remove a screw.
•
The
A
mounting plate should be installed on a wall which can support the weight of the indoor unit.
1) Temporarily secure the
A
mounting plate to the wall, make sure that the plate is completely level, and mark the boring points on
the wall.
2) Secure the
A
mounting plate to the wall with screws.
199
251
81
72
14.5
44
295
257
351
351
798
165
374
23
324
250.5
44.5
103
180
Recommended mounting plate
retention spots (9 spots in all)
Drain hose
position
Through the wall
hole
ɸ
65
Liquid
pipe end
Gas pipe
end
unit : mm
Through the wall hole
ɸ
65
Drain hose
position
Place a leveler on raised tab
(Bolt size : M10)
(Bolt size : M10)
A
Removed pipe
port cover
Mounting plate
The removed pipe port
cover can be kept in the
mounting plate pocket.
A
Use tape measure as shown.
Position the end of a tape
measure at .
Use when securing the unit with
screws.
Refer to “
8. Improving installation
strength
” on page 11.
2.
Boring a wall hole and installing wall embedded pipe
•
For walls containing metal frame or metal board, be sure to use a wall
embedded pipe and wall hole cover in the feed-through hole to prevent
possible heat, electrical shock, or fi re.
•
Be sure to caulk the gaps around the pipes with caulking material to prevent
water leakage.
1) Bore a feed-through hole of 65mm in the wall so it has a down slope
toward the outside.
2) Insert a wall embedded pipe into the hole.
3) Insert a wall hole cover into wall pipe.
4) After completing refrigerant piping, wiring, and drain piping, caulk pipe
hole gap with putty.
ɸ
65
Inside
Wall embedded pipe
(fi eld supply)
Wall hole cover
(fi eld supply)
Wall embedded pipe
(fi eld supply)
Outside
Caulking
(fi eld supply)
3.
Installing inter-unit wiring
1) Remove the screw cover and then the
service lid.
2) Pull out the inter-unit wire from the back
of the indoor unit to the front. It is easier
to pull out if bending up the wire edge in
advance.
3) To connect the inter-unit wire after hooking
the unit onto the
A
mounting plate,
connect the inter-unit wire as shown in the
fi gure.
Flathead screwdriver
Screw cover
Service lid
Hang indoor unit’s
hook here.
Lift the indoor unit
slightly by placing it on
packing or other similar
materials.
Inter-unit wire
When stripping the
ends of inter-unit
wire in advance,
bind right ends of
wires with insulation
tape.
01_EN_3P338604-1E.indd 7
2/18/2019 14:09:15
