Wired Remote Controller
SiUS30-1301
30
Remote Controller
1.3
MAIN/SUB Setting when Using 2 Remote Controllers
Situation
The MAIN/SUB setting is necessary when 1 indoor unit is controlled by 2 remote controllers. When
you use 2 remote controllers (control panel and separate remote controller), set one to MAIN and
the other to SUB.
Setting
The remote controllers are factory setting to MAIN, so you only have to change one remote
controller from MAIN to SUB. To change a remote controller from MAIN to SUB, proceed as
follows:
1.3.1 BRC1E71/72
The designation of the main and sub remote controllers can be swapped. Note that this change
requires turning the power OFF and then ON again.
Select "Switch Main Sub Controller"
and press Menu/OK button.
Service
settings menu
is displayed.
Item 2 is
displayed.
Basic screen
is displayed.
Press and
hold Cancel
button for 4
seconds or
more.
Press
Cancel
button
once.
Press Cancel button.
Item 2 is
displayed.
Press Menu/OK
button.
Select "Main RC"
or "Sub RC" using
the
/
(Up/Down)
buttons, and then
press Menu/OK
button.