17
■
English
Indoor Unit Installation
12�
How to set the different addresses
• When 2 indoor units are installed in one room, the 2 wireless remote controllers can be set for different addresses.
Change the address setting of one of the two units.
When cutting the jumper be careful not to damage any of the surrounding parts.
1) Remove the electrical wiring box. (Refer to “
11� When connecting to an HA system
” on page 16 steps 1)-7).)
2) Cut the address jumper (JA) on the printed circuit board.
3) Cut the address jumper (J4) in the remote controller.
4) Attach the electrical wiring box as they were. (Refer to “
11� When connecting to an HA system
” on page 16 steps 10)-15).)
5) Attach the front panel and the front grille as they were.
Jumper
(J8)
(J4)
J4
ADRESS
EXIST
1
CUT
2
JA ADRESS
EXIST
1
CUT
2
JA
Front metal plate cover
Side metal plate cover
Sensor
securing plate
01_EN_3P379970-3.indd 17
10/29/2014 11:23:49 AM
