FCQG35~1 FCQHG71~140FVEB
Split System air conditioners
3P308369-1C – 2012.10
Installation manual
10
W
IRING
DIAGRAM
Indoor unit
A1P......................Printed circuit board
A2P......................Printed circuit board
A3P......................Printed circuit board (humidity sensor unit)
C21,C105 ............Capacitor
F1U......................Fuse (F, 5 A, 250 V) (only for FCQG35~60)
HAP .....................Light emitting diode (service monitor - green)
M1F .....................Motor (indoor fan)
M1P .....................Motor (drain pump)
M1S~M4S............Motor (swing flap)
R1T......................Thermistor (air)
R2T,R3T ..............Thermistor (coil)
S1L ......................Float switch
SS1......................Selector switch (emergency)
VIR.......................Diode bridge
X1M,X2M.............Terminal strip
Z1C......................Ferrite core
Z1F ......................Noise filter
PS........................Power supply circuit
RC .......................Signal receiver circuit
TC........................Signal transmission circuit
Wired remote controller
R1T ......................Thermistor (air)
Receiver/display unit (attached to wireless remote controller)
A4P,A5P...............Printed circuit board
BS1 ......................ON/OFF button
H1P......................Light emmiting diode (On - Red)
H2P......................Light emmiting diode (Timer - Green)
H3P......................Light emmiting diode (Filter sign- Red)
H4P......................Light emmiting diode (Defrost - Orange)
SS1 ......................Selector switch (MAIN/SUB)
SS2 ......................Selector switch (wireless address set)
Adaptor for wiring
F1U,F2U ..............Fuse (5 A, 250 V)
KCR .....................Magnetic relay
KFR .....................Magnetic relay
KHuR ...................Magnetic relay
Connector for optional parts
X2A ......................Connector (sensor kit)
X8A ......................Connector (auto clean panel)
X24A ....................Connector (wireless remote controller)
X33A ....................Connector (adaptor for wiring)
X35A ....................Connector (group control adaptor)
X36A ....................Connector (auto clean panel)
Notes
1
: Terminal
: Connector
: Field wiring
2
In case of using a central remote controller, connect it to the unit in accordance with the attached installation manual.
3
X2A, X8A, X33A, X35A, X36A are connected when the optional accessories are being used.
In case of using a self cleaning decoration panel, see the wiring diagram of the self cleaning decoration panel.
4
Connect power of ADPTOR FOR WIRING to terminal block (X2M) of indoor unit directly.
5
In case of main/sub change-over, see the installation manual supplied with the remote controller.
6
Colour legend
BLK
: Black
BLU
: Blue
BRN
: Brown
GRN
: Green
GRY
: Gray
ORG
: Orange
RED
: Red
WHT
: White
YLW
: Yellow
In case of simultaneous operation system
:
Indoor unit (Master) / (Slave)
:
To outdoor unit
:
Remote controller
:
Control box
:
Receiver/display unit
:
Central remote controller
:
Wired remote controller
:
Summary of Contents for FCQG100FVEB
Page 14: ......
