PRODUCT DESIGN
5
Location and Clearances
NOTE:
To ensure proper condensate drainage, unit must be
installed in a level position.
Outside Slab Installation
NOTE:
Roof overhang should be no more than 36" and pro-
vision made to deflect the warm discharge air out from the
overhang. Minimum clearances are required to avoid air
recirculation and keep the unit operating at peak efficiency.
Rooftop Installation
NOTE:
To ensure proper condensate drainage, unit must
be installed in a level position.
WARNING
T
O
PREVENT
POSSIBLE
PROPERTY
DAMAGE
,
THE
UNIT
SHOULD
REMAIN
IN
AN
UPRIGHT
POSITION
DURING
ALL
RIGGING
AND
MOVING
OPERATIONS
. T
O
FACILITATE
LIFTING
AND
MOVING
IF
A
CRANE
IS
USED
,
PLACE
THE
UNIT
IN
AN
ADEQUATE
CABLE
SLING
.
IMPORTANT:
If using bottom discharge with roof curb, duct-
work should be attached to the curb prior to installing the
unit.
Refer to Roof Curb Installation Instructions for proper curb
installation. Curbing must be installed in compliance with
the National Roofing Contractors Association Manual.
