6 Web Operation
6.1 Intro to WEB
Note:
Different devices and different versions of WEB may have different interface, please subject to
actual models.
6.1.1 First Time Login
Please follow the steps listed below for network connection.
Step 1. Make sure the HD intelligent traffic camera has connected to the network properly.
1. Connect Ethernet cable into PC port, and connect the other end of cable to device port.
2. Set PC IP address and device IP address to be in the same segment.
Network segment is 192.168.1.X, but do not set to 192.168.1.108.
3. Ping ***.***. ***. *** (device IP address) command on PC, check network.
Step 2. Set separate IP address, subnet mask and gateway for host and device.
Step 1.
If there is no router device in the network, please allocate IP address in the same
segment.
Step 2.
If there is router device, then please set corresponding gateway and subnet mask.
Step 3. In IE enter device IP address, click Enter, log in WEB.
Step 4. In pop-up login interface, enter username and password. Default username and password are
both admin, click Login.
Note:
For device to be initialized, please initialize it first before usage.
Figure 6-1
Summary of Contents for ITC231-RF1A-IR
