Dahua HCVR8204A-S3, User Manual

Page: 312 / 446

302
Step 4 Click Save button to connect device to 3G/4G network.
View the IP address if the connection is OK.
5.7.2.4.2 Mobile
Make sure the SIM card and the 3G/4G module supports SMS function.
Before you set cellphone, please go to the previous chapter to enable Dial/SMS activate
function.
Step 1 From main window->Setup->Network->3G/4G->Mobile.
Enter mobile setup interface. See Figure 5-60.
Figure 5-60
Step 2 Activate or turn off the 3G/4G connected phone or mobile phone, or the phone
you set to get alarm message.
Step 3 Input sender/caller cellphone number and then click to add the cellphone
user to the list.
Note
Select a number in the list and then click to delete current number.

Send SMS: Check the box to enable this function. Various kinds of alarm can
trigger the DVR to send out alarm message to the receiver.

SMS activate: Check the box to enable this function. The user can send out
the message to the receiver to enable/disable 3G/4G module.

Telephone activate: Check the box to enable this function. The user can call
the 3G/4G user to enable/disable 3G/4G module.
Step 4 Click Save to complete the setup.
5.7.2.5 PPPoE
Use PPPoE(Point-to-Point Protocol over Ethernet) to establish network connection.
Device can get a dynamic IP address in the WAN. Before the operation, please contact
your ISP (Internet service provider) for PPPoE user name and password.
Step 1 From main window->Setup->Network->PPPoE.
Enter PPPoE interface. See Figure 5-61.