Dahua DH-XVR4104C-X, User Manual

Page: 197 / 327

Local Configurations 185
Parameter Description
Show Message
Select the Show Message check box to enable a pop-up message
in your local host PC.
Alarm Upload
Select the Alarm Upload check box to enable the system to
upload the alarm signal to the network (including alarm center)
when an alarm event occurs.
Send Email
Select the Send Email check box to enable the system to send an
email notification when an alarm event occurs.
To use this function, make sure the email function is enabled in
Main Menu > NETWORK > EMAIL .
Record Channel
Select the channel(s) that you want to record. The selected
channel(s) starts recording after an alarm event occurs.
The recording for intelligence event and auto recording function
must be enabled. For details, see "5.1.4.9 Configuring Recorded
Video Storage Schedule" and "5.9.1 Enabling Record Control."
PTZ
Click Setting to display the PTZ interface.
Enable PTZ activation function. For each PTZ camera, select the
preset that you want to be called when an alarm event occurs.
Face Detect can only link PTZ preset.
Post Record
Set a length of time for the Device to delay turning off recording
after the alarm is cancelled. The value ranges from 10 seconds to
300 seconds.
Tour
Select the Tour check box to enable a tour of the selected
channels.
Snapshot
Select the Snapshot check box to take a snapshot of the selected
channel.
To use this function, make sure the following settings are
configured:

The snapshot function is enabled for motion detect alarms in
Main Menu > STORAGE > SCHEDULE > Snapshot .
 Select Main Menu > CAMERA > ENCODE > Snapshot , in
the Mode list, select Human Face .
Video Matrix
Select the check box to enable the function. When an alarm event
occurs, the video output port outputs the settings configured in
" Main Menu > DISPLAY > TOUR ."
Not all models support this function.
Buzzer Select the check box to activate a buzzer noise at the Device.
Log
Select the check box to enable the Device to record a local alarm
log.