64
Step 2 Click the map and the position can be set as a waypoint; several waypoints can be
connected together and form a route.
Note
Check total route length, estimated flight time and set "Cycle Flight" at the bottom of the
interface.
Step 3 Click a waypoint and it will become red. Waypoint setting interface will display on the
right of the interface, as shown in Figure 4-17.
Figure 4-17
Step 4 Set waypoint parameters. Please refer to Table 4-1 for more details.
Parameter
Note
Altitude
Set flight altitude of waypoint.
Speed
Set flight speed of waypoint
Head direction
Set head direction of waypoint according to requirement during flight.
Residence time
Set hovering time after the aircraft reaches a waypoint.
Latitude
and
longitude
Automatically acquire latitude and longitude of the waypoint when
adding the waypoint.
Manually set waypoint latitude and longitude. Waypoint position will
skip to manual setting point after setting is done.
Waypoint action
No action: it is not to set waypoint action.
Shutter: it will take photos after the aircraft arrives at the waypoint.
Action cycle
Action cycle setting is invalid when the waypoint action selects "No
Action".
When waypoint action selects "Shutter", input time. The aircraft
arrives at the waypoint and it will take a photo after a period of time.
Note
Action cycle shall be less than or equal to residence time.
Table 4-1
Step 5 Click "Save" to make configuration valid.
Summary of Contents for NAVIGATOR X1550
