Operation Section
-66-
8. G424E/G430E Engine Malfunction
Indicator Lamp (MIL)
G424E and G430E engine control
systems are equipped with built-in fault
diagnostics. Deteted system faults can be
displayed by the Malfunction Indicator Lamp (MIL)
as Diagnostic Fault Codes (DFC) or flash codes,
and viewed in detail with the use of service tool
software. When the ignition key is turned ON the
MIL will perform a self-test, illuminate once and
then go OFF. If a detected falut condition exists, the
fault or faults will be stored in the memory of the
engine control module (ECM). Once a fault occurs
the MIL will illuminate and remain ON. This signals
the operator that a faults has been detected by the
SECM.
9. Seat Belt Warning Light (If
Equipment)
Indicates when the seat belt dose not
fastened by operator.
The light will come on when the ignition switch is
turned to the on position.
The light should go off after engine is started.
10. Horn Switch -
Push on the horn
button to sound the horn.
11. Service hour Meter -
Indicates the
total number of hours the engine and the
lift truck have operated. The hour meter
will operate when the ignition switch is in the ON
position, whether the engine is running or not. The
hour meter is used to determine lubrication and
maintenance intervals.
