Daewoo EGSP-130E, Technical & Service Manual

Page: 3 / 55

Operation instructions
Model: EGSP-13E EGSP-130E
5
Power on light: To come on when Power ON/OFF
button is pressed down.
1
2
3
4
ON/OFF Button: To turn on/off the power supply.
Salt and Rinse Aid Warning Light: To come on when
the softener or dispenser needs to be refilled.
Program indicator light: when you select washing
program, the correspond light will display.
Program button :To select washing program
when press the button.
— Strong — Normal
— Economy — Rinse
— Rapid
Prog. Prog. Prog.
AUS
EIN
2 1 4 5 6 3
4
5
Turning on the Appliance
Starting a wash cycle...
Draw out the lower and upper basket, load the dishes and
push them back. It is commended that loading the lower
basket first, than the upper one (see the section entitled
“ Loading the Dishwasher ” ).
Pour in the detergent (see the section entitled “ Salt,
Detergent and Rinse Aid ” ).
Insert the plug into the socket. The power supply is 220-240
VAC 50 HZ, the specification of the socket is 12 A 250 VAC.
Make sure that the water supply is turned on to full pressure.
Open the door,press the ON/OFF button,and the ON/OFF light
will turn .
Press the "prog. "Button to select a desired "Wash cycle".(see
the section entitled."Wash Cycle Table".)
With a little force to ensure the door is properly closed.
NOTE: A click could be heard when the door is closed perfectly.
When the washing is over, you can shut off the switch by
pressing ON/OFF button.
on
Change the Programme . . .
Premise: A cycle that is underway can only be modified if it
has only been running for a short time. Otherwise, the detergent
mayhave already been released, and the appliance may have
already drained the wash water. If this is the case, the detergent
dispenser must be refilled (see the section entitled " Loading the
Detergent " ).
Open the door,Press current prog. Button more than three
seconds to cancel the program ,then you can change the
program to the desired cycle setting (see the section entitled
" Starting a wash cycle. . . " ). Then, close the door.
NOTE: If you open the door when washing, the machine
will pause. When you close the door , the machine will
keep on working after 10 seconds.
The 7 program lights shows the state of the dishwasher:
a) All program lights off --> stand by
b) One of the program lights on --> pause
c) One of the program lights blinking --> run
1
2
3
4
5
6
If all the lights begin to glimmer, that indicates the
machine is out of order, please turn off themain
power and water supply before calling a service.
NOTE:
Prog.
Prog. Prog.
AUS
EIN
2 1 4 5 6 3
4
5
Model: EGSP-9E EGSP-90E
2