Daedong KIOTI DK35SE, Manual

Page: 61 / 221

4
-12
DK35(CH)SE/DK40(CH)SE/DK45(C)HSE
This switch is used to switch the PTO
between automatic and manual
operation. The following can be done
with the PTO.
1. PTO engagement (Automatic)
When the PTO selection switch is
put to the automatic operation
position, the PTO is automatically
disengaged after the hydraulic lifting
arm (or implement) is lifted by the
position control lever.
PTO SELECTION SWITCH
(1) PTO Selection Switch
(A) Automatic
(B) Manual
H11O415A
2. PTO engagement (Manual)
When the PTO selection switch is
put to the manual operation position,
the PTO is operated regardless of the
height of the lifting arm (implement).
3. To disengage the PTO:
Press the PTO switch to the “OFF”
position.
The mark “ " on the tachometer
indicates 540 rpm of the PTO.
When engaging the PTO, lower
the engine speed, engage the
PTO, and then accelerate the
tractor gradually in order to pre-
vent impact load to the PTO
from abrupt operation.
IMPORTANT
NOTE
To avoid personal injury and
accident:
Before disassembling or clean-
ing the PTO system, make sure
that the PTO switch is in the
“OFF” position, the engine is
stopped, and all parts are
stopped.
Always keep the PTO driving
part clean and the PTO cover at-
tached in its position.
Disengage the PTO and the con-
necting shaft while driving on a
road.
Be careful not to get your hand,
foot, cloth, or hair into any driv-
ing part while the PTO is in
operation. You can be severely
injured.
!!!!!
CAUTION
IMPORTANT
Make sure that no one is around
the tractor and implement while
the PTO is in operation.