D-Link xStack DGS-3120 Series, Cli Reference Manual

Page: 867 / 1150

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
862
Format
disable rip
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To disable RIP:
DGS-3120-24TC:admin#disable rip
Command: disable rip
Success.
DGS-3120-24TC:admin#
87-3 config rip
Description
This command is used to configure the RIP settings for one or more IP interfaces.
Format
config rip [ipif <ipif_name 12> | all] {authentication [enable <password 16> | disable] |
tx_mode [disable | v1_only | v1_compatible | v2_only] | rx_mode [v1_only| v2_only |
v1_or_v2 | disable] | state [enable | disable] | distribute_list_in [access_list <list_name 16> |
none]}(1)
Parameters
ipif_name - Specify the IP interface name used for this configuration.
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12
characters long.
all - Specify that all the IP interfaces will be used in this configuration.
authentication - Specify to set the state of authentication.
enable - Specify that the authentication state will be enabled.
<password 16> - When the authentication state is enabled, enter the password used here.
This value can be up to 16 characters long.
disable - Specify that the authentication state will be disabled.
tx_mode - Specify the RIP transmission mode.
disable - Specify to prevent the transmission of RIP packets.
v1_only - Specify that only RIP version 1 format packets will be transmitted.
v1_compatible - Specify to transmit RIP version 2 format packets to the broadcast address.
v2_only - Specify that only RIP version 2 format packets will be transmitted.