D-Link xStack DGS-3120 Series, Cli Reference Manual

Page: 1099 / 1150

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
1094
all - Configure all the Switch ports’ WAC state.
state - (Optional) To specify the port state of WAC
enable - Specify that the port state of WAC will be enabled.
disable - Specify that the port state of WAC will be disabled.
aging_time - (Optional) A time period during which an authenticated host will keep in
authenticated state.
infinite - Indicates never to age out the authenticated host on the port
<min 1-1440> - Enter the aging time period here. This value must be between 1 and 1440
minutes.
idle_time - (Optional) If there is no traffic during idle time, the host will be moved back to
unauthenticated state
infinite - Indicates never to check the idle state of the authenticated host on the port.
<min 1-1440> - Enter the idle time period here. This value must be between 1 and 1440
minutes.
block_time - (Optional) If a host fails to pass the authentication, it will be blocked for a period
specified by “block_time”.
<sec 0-300> - Enter the blocking time here. This value must be between 0 and 300 seconds.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To config state and other parameters of the ports:
DGS-3120-24TC:admin#config wac ports 1:1-1:9 state enable
Command: config wac ports 1:1-1:9 state enable
Success.
DGS-3120-24TC:admin#
120-4 config wac method
Description
This command is used to specify the RADIUS protocol used by WAC to complete RADIUS
authentication.
WAC shares other RADIUS configuration with 802.1X, when using this command to set the
RADIUS protocol, you must make sure the RADIUS server added by the
config radius add
command supports the protocol.
Format
config wac method [local | radius]
Parameters
local - The authentication will be done via the local database.
radius - The authentication will be done via the RADIUS server.