4 Configuration
D-Link Smart Managed Switch User Manual
32
Figure 4.44 - L2 Features > Loopback Detection Settings
The fields that can be configured are described below:
Item
Description
Loopback Detection Global Settings
Loopback Detection
Specify to enable or disable loopback detection function. The
default is
Disabled.
Time Interval (1-255)
Set a Loop detection Interval between
1
and
255
seconds. The
default is
10
seconds.
Recover Time (0 or 60-
255)
Time allowed (in seconds) for recovery when a Loopback is
detected. The Loop Detection Recover Time can be set at
0
seconds, or
60
to
255
seconds. Entering
0
will disable the
Loop Detection Recover Time. The default is
60
seconds
Loopback Detection Port Settings
From Port / To Port
Select the range of ports to enable or disable Loopback
Detection for.
State
Enable or disable Loopback Detection for the specified range
of ports.
Table 4.25
Click
Apply
to make the configurations take effect.
Click
Refresh
to renew the Loopback Detection table.
L2 Features > Link Aggregation
The Link Aggregation function enables the combining of two or more ports together to increase bandwidth.
Each Link Aggregation group supports a maximum of four ports.
