43
D-Link DIR-890L User Manual
Section 3 - Configuration
PPPoE
Choose
Share with IPv4
to re-use your IPv4 PPPoE username and
password, or
Create a new session
.
If you selected
Create a new session
above, enter the PPPoE
Username
provided by your ISP.
If you selected
Create a new session
above, enter the PPPoE
Password
provided by your ISP.
Select
Static IP
if your ISP assigned you the IP address, subnet mask,
gateway, and DNS server addresses. In most cases, select
Dynamic IP
.
Enter the
IP Address
provided by your ISP (for Static IP only).
If you selected
Create a new session
above, enter the ISP
Service
Name
(optional).
If you selected
Create a new session
above, select either
Always
on
,
On demand
, or
Manual
.
Maximum Transmission Unit - you may need to change the MTU for
optimal performance with your ISP.
Select either
Obtain DNS server address
or
Use the following DNS
.
If you selected
Use the following DNS
, enter the
Primary DNS
Server
address.
If you selected
Use the following DNS
, enter the
Secondary DNS
Server
address.
PPPoE Session:
Username:
Password:
Address Mode:
IP Address:
Service Name:
Reconnect
Mode:
MTU:
DNS Type:
Primary DNS
Server:
Secondary DNS
Server:
Select
PPPoE
(Point-to-Point-Tunneling Protocol) if your Internet connection requires you to enter a username and password. This information can
be provided by your Internet service provider (ISP). Required fields will vary, depending on the options you have enabled.*
Note
:
When you select
Share with IPv4
and
Dynamic IP
instead of
Create a new session
and
Static IP,
less fields are required. See screen shot on the next page.