DIR-430 RangeBooster G Wireless Router User’s Guide
Version : 1
.0
ȱ
Traffic not related to any of the above applications would be allowed to pass
through the Gateway by default.
To add a firewall policy for your own application, click on
Add New User Defined
Policy
hyperlink close to the top of the page shown on the previous page, to
access the configuration page as shown below. The configuration makes the
firewall allow/deny the traffic requested from the internal network to the Internet
(outbound traffic). This uses concept of Network Address Translation (NAT),
hence the DIR-430 allows all Local PCs to use same public IP address. All pre-
defined policies shown in the figure on the previous page use the same concept.
Network Filter configuration requires you to provide:
Remote Network:
The remote host domain name/IP address or subnet or IP
address range (select "
Any
" radio button if required for all machines) to which
connections will be made.
Local Network:
Local host IP address or subnet or range of IP addresses (or
select a radio button for "
ALL
" machines) from which the connections will be
made.
For Services:
A pre-determined service from the drop-down list or specify port
range (if only one port exists, provide duplicate entry) with transport protocol
(TCP/UDP).
Priority:
Choose a priority level if Uplink Bandwidth and QoS are enabled.
Should be:
Select whether this policy should allow or deny traffic.
Access Schedule:
Select the access schedule policy to be used (
always
by
default). All the added time windows will appear in the drop-down list.
Once the configuration is complete, click the
Add
button to add the policy into the
list.
Page
ȱ
42
ȱ
of
ȱ
103
ȱ
