DIR-430 RangeBooster G Wireless Router User’s Guide
Version : 1
.0
ȱ
Appendix D: FCC Interference Statement
This
ȱ
equipment
ȱ
has
ȱ
been
ȱ
tested
ȱ
and
ȱ
found
ȱ
to
ȱ
comply
ȱ
with
ȱ
the
ȱ
limits
ȱ
for
ȱ
a
ȱ
Class
ȱ
B
ȱ
digital
ȱ
device,
ȱ
pursuant
ȱ
to
ȱ
Part
ȱ
15
ȱ
of
ȱ
the
ȱ
FCC
ȱ
Rules.
ȱȱ
These
ȱ
limits
ȱ
are
ȱ
designed
ȱ
to
ȱ
provide
ȱ
reasonable
ȱ
protection
ȱ
against
ȱ
harmful
ȱ
interference
ȱ
in
ȱ
a
ȱ
residential
ȱ
installation.
ȱȱ
This
ȱ
equipment
ȱ
generates,
ȱ
uses
ȱ
and
ȱ
can
ȱ
radiate
ȱ
radio
ȱ
frequency
ȱ
energy
ȱ
and,
ȱ
if
ȱ
not
ȱ
installed
ȱ
and
ȱ
used
ȱ
in
ȱ
accordance
ȱ
with
ȱ
the
ȱ
instructions,
ȱ
may
ȱ
cause
ȱ
harmful
ȱ
interference
ȱ
to
ȱ
radio
ȱ
communications.
ȱȱ
However,
ȱ
there
ȱ
is
ȱ
no
ȱ
guarantee
ȱ
that
ȱ
interference
ȱ
will
ȱ
not
ȱ
occur
ȱ
in
ȱ
a
ȱ
particular
ȱ
installation.
ȱȱ
If
ȱ
this
ȱ
equipment
ȱ
does
ȱ
cause
ȱ
harmful
ȱ
interference
ȱ
to
ȱ
radio
ȱ
or
ȱ
television
ȱ
reception,
ȱ
which
ȱ
can
ȱ
be
ȱ
determined
ȱ
by
ȱ
turning
ȱ
the
ȱ
equipment
ȱ
off
ȱ
and
ȱ
on,
ȱ
the
ȱ
user
ȱ
is
ȱ
encouraged
ȱ
to
ȱ
try
ȱ
to
ȱ
correct
ȱ
the
ȱ
interference
ȱ
by
ȱ
one
ȱ
of
ȱ
the
ȱ
following
ȱ
measures:
ȱ
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
This
ȱ
device
ȱ
complies
ȱ
with
ȱ
Part
ȱ
15
ȱ
of
ȱ
the
ȱ
FCC
ȱ
Rules.
ȱ
Operation
ȱ
is
ȱ
subject
ȱ
to
ȱ
the
ȱ
following
ȱ
two
ȱ
conditions:
ȱ
(1)
ȱ
This
ȱ
device
ȱ
may
ȱ
not
ȱ
cause
ȱ
harmful
ȱ
interference,
ȱ
and
ȱ
(2)
ȱ
this
ȱ
device
ȱ
must
ȱ
accept
ȱ
any
ȱ
interference
ȱ
received,
ȱ
including
ȱ
interference
ȱ
that
ȱ
may
ȱ
cause
ȱ
undesired
ȱ
operation.
ȱ
FCC
ȱ
Caution:
ȱ
Any
ȱ
changes
ȱ
or
ȱ
modifications
ȱ
not
ȱ
expressly
ȱ
approved
ȱ
by
ȱ
the
ȱ
party
ȱ
responsible
ȱ
for
ȱ
compliance
ȱ
could
ȱ
void
ȱ
the
ȱ
user
ȇ
s
ȱ
authority
ȱ
to
ȱ
operate
ȱ
this
ȱ
equipment.
ȱ
IMPORTANT NOTE: FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm between the
radiator & your body.
This
ȱ
transmitter
ȱ
must
ȱ
not
ȱ
be
ȱ
co
Ȭ
located
ȱ
or
ȱ
operating
ȱ
in
ȱ
conjunction
ȱ
with
ȱ
any
ȱ
other
ȱ
antenna
ȱ
or
ȱ
transmitter.
ȱ
We
ȱ
declare
ȱ
that
ȱ
the
ȱ
product
ȱ
is
ȱ
limited
ȱ
in
ȱ
CH1
Ȭ
CH11
ȱ
for
ȱ
2.4G
ȱ
band
ȱ
by
ȱ
specific
ȱ
firmware
ȱ
controlled
ȱ
by
ȱ
the
ȱ
manufacturer
ȱ
and
ȱ
is
ȱ
not
ȱ
user
ȱ
changeable.
ȱ
IC statement
Operation is subject to the following two conditions:
1) This device may not cause interference and
2) This device must accept any interference, including interference that may cause undesired operation of the device.
This device has been designed to operate with an antenna having a maximum gain of 2 dBi. Antenna having
a higher gain is strictly prohibited per regulations of Industry Canada. The required antenna impedance is 50 ohms.
IMPORTANT NOTE:
IC Radiation Exposure Statement:
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. End users must
follow the specific operating instructions for satisfying RF exposure compliance. This equipment should be installed
and operated with minimum distance 20cm between the radiator & your body. This transmitter must not be co-located
or operating in conjunction with any other antenna or transmitter.
Reglement d'Industry Canada
Les conditions de fonctionnement sont sujettes a deux conditions:
1) Ce peripherique ne doit pas causer d'interference et.
2) Ce peripherique doit accepter toute interference, y compris les interferences pouvant perturber le bon
fonctionnement de ce peripherique.
Page
ȱ
103
ȱ
of
ȱ
103
ȱ
