xStack
®
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
156
Figure 6 - 10. Access Rule List window for Ethernet
To remove a previously created rule, click the corresponding
Delete Rules
button. To add a new Access Rule, click the
Add Rule
button:
Figure 6 - 11. Add Access Rule window for Ethernet
To set the Access Rule for Ethernet, adjust the following parameters and click
Apply
.
Parameter Description
Access ID (1-200)
Type in a unique identifier number for this access. This value can be set from
1
to
200
.
Auto Assign – Ticking this check box will instruct the Switch to automatically assign an Access ID
for the rule being created.
Action
Select
Permit
to specify that the packets that match the access profile are forwarded by the
Switch, according to any additional rule added (see below).
Select
Deny
to specify that packets that do not match the access profile are not forwarded by the
Switch and will be filtered.
Select
Mirror
to
specify that packets that match the access profile are mirrored to a port defined
in the config mirror port command. Port Mirroring must be enabled and a target port must be set.
Priority (0-7)
Tick the corresponding check box if you want to re-write the 802.1p default priority of a packet to
the value entered in the Priority field, which meets the criteria specified previously in this
command, before forwarding it on to the specified CoS queue. Otherwise, a packet will have its
incoming 802.1p user priority re-written to its original value before being forwarded by the Switch.
For more information on priority queues, CoS queues and mapping for 802.1p, see the QoS
section of this manual.
Replace Priority
Tick this check box to replace the Priority value in the adjacent field.
