DES-3226S Layer 2 Fast Ethernet Switch User’s Guide
72
To enable or disable GVRP, globally, on the Switch
:
Go to the
VLAN Configurations
link and click on the
Switch GVRP
link:
Figure 6 - 44. – Switch GVRP
Parameter
Description
GVRP
<Disabled>
Group VLAN Registration Protocol (GVRP) – this enables and disables GVRP on the
Switch without changing the port GVRP settings.
Asymmetric VLANs
The DES-3226S supports Asymmetric VLANs implementation for more efficient use of shared resources such as server or
gateway devices. An asymmetric VLAN can be set up to allow a server (or several servers) to communicate with several
clients through a single physical link on the Switch. At the same time however, the clients are not allowed to link to each other
directly. For example, asymmetric VLANs can be set up so that the network email server can be accessed by all email clients.
All email clients can send and receive data packets through the port connected to the email server, but they are not allowed to
send and receive data to the remaining ports. The email server can freely associate with all ports, that is, all clients connected
to the Switch.
The key difference between conventional 802.1q VLAN implementation or symmetric VLANs, and asymmetric VLANs is in
how address mapping is handled. Symmetric VLANs use separate address tables so there is no address sharing between
VLANs. Asymmetric VLANs can use a single, shared address table. Address sharing however takes place in only one
direction. In the example above, the VLAN created for the port connected to the email server has the entire address table at its
disposal so that any address can be mapped to its port (PVID).
This feature can be enabled with the following important restrictions:
•
Asymmetric VLAN support is limited to standalone Switches.
•
Each participating port must be untagged.
•
GVRP and IGMP Snooping is not supported.
When Asymmetric VLANs have been enabled, a unique PVID is assigned to all ports creating a separate VLAN for each port.
Each port is still able to receive frames from the defult VLAN. Asymmetric VLANs are disabled by default.
Figure 6 - 45. Asymmetric VLANs (enable or disable)
To enable Asymmetric VLANs for a standalone Switch, select
Enabled
and click the
Apply
button.
Summary of Contents for DES-3226S
Page 126: ......
