19
SETTING THE OVERCURRENT
It is recommended that the current sensing is left as set in the factory. Increasing the current sensing
may cause serious injury or damage in the case of the gate striking a person or object.
Overcurrent is the amount of force that the motor delivers before stopping when an object is struck.
The amount of force is controlled by the two potentiometers (pots) found on the main PC board.
To increase the amount of force turn the pots clockwise. To decrease the amount of force turn the
pots counter clockwise.
NOTE! the current sensing is set in the factory and should only be
changed if absolutely necessary.
Using a small flat screwdriver
turn the pots to increase or
decrease the current sensing
of the motor
To
program
remotes
to
the
on-board
receiver
complete
the
following
steps.
(Note: once remotes are
programmed, the jumper must not be left on both pins, can be connected to 1 pin for safe storage)
It
is
recommended
that
the
remotes
are
numbered
in
order
of
programming.
This
will
assist
with
erasing
any
lost
or
stolen
remote
at
a
later
stage.
Step 1:
place the jumper over the two pins on the PC Board called TX- L and leave on
Step 2:
press and hold the button that is to trigger the gate opener on the remote for 2 seconds,
repeat process this step for each remote
Step 3:
remove
the
jumper
from
the
two
pins.
That
particular
button
on
the
remote
s
is
now
programmed
to
the
receiver.
PROGRAMMING THE REMOTES
3
1
2
ERASING ALL REMOTES PROGRAMMED TO THE RECEIVER
1: insert learn jumper over pins marked TX-L and d
o
NOT remove the jumper
2: for pedestrian opening press a remote button until the LED flashes twice.
3: release button
4: continue the above steps to add additional
remotes for pedestrian opening to a maximum of 18
remotes.
5: remove jumper
Please note if auto close is on the pedestrian mode will work on the auto close time
Step1:
place
the
jumper
over
the
two
pins
called
TX-E
Step2:
LED will flash 10 times or once it flashes erratic, then remove jumper
PROGRAM REMOTES FOR PEDESTRIAN OPENING ONLY
