D.A.C.E SPRINT, Manual

Page: 14 / 21

1
4
VERY IMPORTANT: GEARBOX MUST BE FILLED WITH THE SUPPLIED OIL BEFORE THE MOTOR IS
OPERATED!
As shown above, with the gate in the closed position , the magnet must be mounted 700 mm from the
centre of the motor.
If it is not possible to mount the magnet at 700mm, this distance may be extended very slightly. The mag­
net must not be inverted. If the magnet is moved for any reason after the motor has been programmed,
then the motor will have to be re­programmed.
MOUNTING THE MAGNET
The gap between the motor and the magnet, when the magnet passes the motor, must not exceed 3mm.
To check this, manually move the gate until the magnet is directly over the pinion gear then measure be­
tween the magnet and the motor lid. If the gap is more than 3mm, place washers behind the magnet until
the correct gap is achieved
FILLING THE GEARBOX OIL
700 mm
Magnet
Place washers here if gap
is not correct
Maximum gap between the magnet and the motor
3 mm
Fill the gearbox as shown bellow. The entire
bottle needs to be emptied into the gearbox.
The gearbox oil level needs to be checked periodi­
cally. To check the oil level, remove the oil level
screw . Oil should be added until the oil just starts
to run out of the hole.
REPLACE THE SCREW!
Oil level screw
Use S.A.E.75W/90 oil to refill the gearbox