WPT Installation Manual
Document No. 910-00005-01, Rev 17
Page 6 of 19
Figure 7. WPT Batteries
2.1.3
Installing/Replacing Batteries
Replace battery with Type CR123A, that meet UL-1642, as evidenced by UL
component recognition mark, only (from Panasonic, Energizer or Duracell). Use of
any other battery may present a risk of fire or explosion. See Figure 7 for correct
polarity.
•
Underwriters Laboratories Recognition Mark:
•
Caution: The battery used in this device may present a fire or chemical burn
hazard if mis-treated. Keep away from children and/or other untrained
personnel. Do not recharge, disassemble, heat above 100 ºC (212 ºF), or
dispose of in fire.
•
Dispose of used battery promptly in accordance with local regulations (place in
plastic bag and recycle if possible).
•
Do not insert batteries with the
and polarities reversed.
•
Do not short-circuit.
•
Be sure to wrap each battery when disposing or storing to avoid short circuit.
•
If leaked liquid gets in the eyes, wash them with clean water and consult a
physician immediately.
•
Do not use new and used batteries together. Do not use different types of
batteries together.
•
Do not apply strong pressure to the batteries nor handle roughly.
•
Do not use or leave the batteries in direct sunlight or in high-temperature areas.
2.2
Configuring the WPT
NOTE: When installing the WPT in a standalone mode, please skip to Section 2.2.4.
The WPT can be configured using the LCD display and the 3 front buttons. The
menu structure is displayed below. Please refer to this diagram while calibrating and
configuring the WPT.